Cleaning Stamped Concrete With Muriatic Acid

It cannot be used as a cleaner though it doesn t remove dirt and grease and other soils and it will attack stamped concrete regardless of whether the stamping makes the concrete look like brick or stone.

Cleaning stamped concrete with muriatic acid.

Mix the solution dilute the acid with water at a 1 to 4 ratio. Always add the acid to the water to help prevent acid. For many years it has been the standard cleaning method to prepare concrete for coatings installations to remove stains of any type from concrete and to remove concrete slurry or efflorescence from bricks. Because the profiler a muriatic acid in a gel form lays on the surface of the concrete without absorbing into the cement.

Add cool water to your container and then wearing full protective gear slowly pour in the muriatic acid. Scrub the wall sidewalk or patio with the acid mix the scrub brush holds. Yes muriatic acid attacks mortar and concrete quicker than it attacks brick and is therefore sometimes used to clean mortar off of brick. Muriatic acid acts like liquid sandpaper by roughening the surface of the concrete.

Allow the acid to work upon the surface for a few minutes. Then proceed by thoroughly rubbing and rinsing the patio using a long handled broom and garden hose. Wear proper protection muriatic acid is highly corrosive. Muriatic acid can work wonders on filthy concrete and it can also be very useful in cleaning excess smears of dried mortar and grout or when attempting to alleviate tough rust stains.

It s quite dangerous stuff to use but it can be done. It can burn your skin and cause choking sinus irritation or. It only removes hard mineral deposits from the surface without deteriorating the cement. It also reduces the surface alkalinity of the concrete that can cause some paints to adhere poorly.

Mix 1 cup of baking soda garden lime or household ammonia in 1 gallon of water roughly 250 ml in 4 l or follow label instructions on an acid neutralizing product. The profiler actually need only sit on the surface for about 5 to 15 minutes. Dilute the acid according to packaged instructions and apply it to the stamped concrete patio using a wet mop. Scrub this over the concrete and let sit at least ten minute to ensure that all the acid is neutralized.

The most common acids used to clean concrete and bricks are hydrochloric acid muriatic or phosphoric acid. This helps to keep the exposed aggregate in place. You roughen such a floor by etching it with muriatic acid. Use a chemically formulated acid based concrete cleaner for this.

Use a sprayer to soak the spots which need cleaning. Do not ever mix any other chemicals with muriatic acid. Stubborn stains might also need to be scrubbed with a stiff wire bristled brush.